Brought to you by
Brought to you by
This is an old revision of the document!
Author: Soeren Peper, Passivhaus Institut Darmstadt
A key issue that often arises with reference to realised innovative, energy efficient buildings and retrofits is whether the planned low energy demand is actually achieved in a measurable way. The aim is to determine the total consumption of a building using simple means and with as little effort as possible, and to be able to differentiate between the areas for heating, hot water and electricity use as far as possible. This question has nothing to do with significantly more extensive scientific analyses.
In this connection, the term “minimal monitoring” should be understood to mean “an efficiency review of a building regarding its energy consumption using minimal effort”.
The question that arises is: what is needed to achieve this objective and what is unnecessary? What is the extent of the conclusions of such an investigation and what exactly can or cannot be said about that building? The measurement e.g. of the total gas consumption is very easy, but determining the share for heating without hot water generation, distribution and conversion losses requires much more effort. The solutions presented here are based on at least monthly meter readings taking place manually without the use of a complicated data acquisition system. They are intended to enable an initial analysis of the building without major technical effort.
Download (pdf 1,3 MB) of the report “Concept for a minimal monitoring of
different buildings undergoing step-by-step energy-efficient refurbishment ” on www.europhit.eu that has been written in the context of the EuroPHit project.
The most important points regarding minimal monitoring are summarised below:
Despite the limited accuracy of this method for estimation of heat consumption and disregarding of the various influencing factors, this provides a valuable overall picture for an initial assessment of the building.
Calculation of the primary energy use is reliable due to the use of the total unadjusted final energy consumption and can be used successfully for checking compliance with the PE limit value.
|The sole responsibility for the content of Passipedia lies with the authors.
While certain marked articles have been created with the support of the EU, they do not necessarily reflect the opinion of the European Union;
Neither the EACI nor the European Commission are responsible for any use that may be made of the information contained therein.